MIL-DTL-81905G(AS)
3.9.1.5 Laundering (care) instruction label. The laundering instruction label shall conform
to MIL-DTL-32075, type VI, class 3 and shall be 4 by 1½ inches. The instruction label shall
contain the following information:
DO NOT MACHINE WASH, MACHINE DRY, IRON
OR DRY CLEAN TO AVOID POTENTIAL DAMAGE
TO QUICK DISCONNECT HARDWARE AND HOSE
ASSEMBLY. PLUG AIR INLET PORT SECURELY
TO
PREVENT
WATER
FROM
ENTERING
BLADDERS AND AS NEEDED, WASH BY HAND
(SPOTCLEAN) WITH MILD SOAP AND COLD
WATER. HANG ON A WOODEN HANGER OR LAY
FLAT IN A WELL VENTILATED AREA TO AIR
DRY.
THE MATERIAL OF THE OUTER SHELL OF THIS
ANTI-G GARMENT IS AN INHERENTLY FIRE
RESISTANT MATERIAL THAT WILL NOT LOSE
ITS FIRE RESISTANT PROPERTIES DURING
WASHING.
3.9.1.6 Item Unique Identification (IUID) label. The contractor shall attach an
Item Unique Identification (IUID) label to each unit in accordance with DFARS Clause
252.211-7003 Item Identification and Valuation.
3.9.1.7 Barcode label. Each item shall be individually bar-coded with a MIL-DTL-32075,
type VIII, class 17 label/tag. The label/tag shall be located on the bag so that it is completely
visible when it is folded or packaged as specified.
3.10 Special identification. The abdominal area of each anti-G garment that has been
subjected to the endurance test specified in 4.9.3 shall be marked, with waterproof ink, in letters
that are at least 1 inch high. The marking shall be as follows: ENDURANCE TESTED NOT
TO BE USED IN FLIGHT. The shipping containers for anti-G garments that have been
subjected to the endurance test specified in 4.9.3 shall be marked in letters that are at least 1 inch
high that repeats ENDURANCE TESTED NOT TO BE USED IN FLIGHT.
3.11 Patterns. The Government will provide a complete set of patterns (see table VIII)
which show size, directional lines, placement marks, and notches for assembly. The Government
pattern shall be used to create a working pattern. The Government pattern shall not be altered.
Minor modifications are permitted to the working pattern where necessary when using automatic
equipment or to accommodate a manufacturing process. These modifications shall not alter the
dimensional, serviceability, or appearance requirements cited in this specification.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business