MIL-DTL-85633C
CWU-XX/P (XX shall either be 62B for Type I or 74 for Type II or 62C for Type III or
86 for Type IV or 87 for Type V)
Anti-Exposure Flyers Coverall (For Types I, II, and III)
Anti-Exposure Flyers Ruggedized Coveralls (For Types IV and V)
Date of manufacture (month/year)
Serial Number (see 3.5.3)
CAUTION. (10 point). Machine wash cold with powdered detergent. Drip or tumble
dry low.
DO NOT DRY CLEAN
REMOVE WATCHES AND JEWELRY BEFORE DONNING AND DOFFING.
Coverall cloth can be damaged. Sharp instruments can puncture or abrade surfaces. Use
care when donning or doffing. Ensure zippers are securely closed after donning.
3.5.3 Serial numbers. The coveralls shall be identified by individual serial numbers
which shall be assigned by the manufacturer. Serialization shall be by a block of consecutive
numbers to cover the entire acquisition document quantity.
3.6 Design.
3.6.1 Type I (CWU-62B/P). The design of the type I coveralls shall conform to the
requirements of applicable drawings (see 2.2.2). The coveralls shall be one piece garment
containing a neck seal and an omni-environmental barrier entry and a portal zipper
(see figure 1).
3.6.2 Type II (CWU-74/P). The design of the type II coveralls shall conform to the
requirements of applicable drawings (see 2.2.2). The coveralls shall be a one piece garment
containing a neck seal, wrist seals, pockets, socks, and an omni-environmental barrier entry and a
portal zipper (see figure 2).
3.6.3 Type III (CWU-62C/P). The design of the type III coveralls shall conform to the
requirements of applicable drawings (see 2.2.2). The coveralls shall be a one piece garment
containing a neck seal and omni-environmental barrier entry zipper. The zipper shall have a
thong to enable the wearer to pull it open and close up and down the back (see figures 3 and 4).
3.6.4 Type IV (CWU-86/P). The design of the type IV coveralls shall conform to the
requirements of the applicable drawings (see 2.2.2). The coverall shall be a one piece garment
containing a neck seal, wrist seals, an omni-environmental barrier entry and a portal zipper,
overvest, and pockets (see figures 5 and 6).
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business